BARIX Streaming Client Bedienungsanleitung PDF herunterladen (Seite 20)

Stream to Shoutcast source entry

Set the connection type to “Shoutcast source” to connect (TCP) to a single Shoutcast server. Enter

IP and port of the Shoutcast server for the device to act as a Shoutcast source. When

authentication is needed please read also section Ice/Shoutcast (Security settings).

The IP “0.0.0.0” will let the Instreamer act as a Shoutcast server itself waiting for a connection on

the port selected under “Port#”. The function is then limited to a single client (a media player like

Winamp) and only one entry is allowed to be set to Shoutcast server (IP 0.0.0.0).

IP Address

Enter 4 values of the destination IP address e.g.:

"0.0.0.0" for unused destinations (except when the connection type is set to UDP it will be

broadcasted e.g. "192.168.0.255").

"0.0.0.0" for connection TCP + Port if this device is used as a TCP listener waiting for a connection

from a streaming device. (default)

"192.168.0.34" for a directed connection

"192.168.0.255" for a broadcast

Default settings for the ﬁrst entry is "RTP 0.0.0.0:4444".

Default settings for other entries is "Internet Radio 0.0.0.0:0".

Domain Name

If an active connection is required within the ﬁrst 4 entries, a Domain Name or an IP address can

be provided. An example of a Domain Name is www.myserver.com. If an IP address is provided,

e.g. 192.168.0.34, then this is used, otherwise the device attempts to obtain the IP address from a

Domain Name Server.

Port #

Enter the port number for each destination (between 0 and 65535). If this port is set to 0 then the

default ports are used (Internet Radio 80, TCP 2020, UDP 3030). For Shoutcast, enter the base

port (the lower one, the same as clients put into their radio players).

SNMP settings

SNMP settings are located in the streaming section and are for advanced users only. Different

SNMP traps can be generated depending on the state of the Barix Instreamer. The traps are

triggered according to speciﬁc audio values as described below. Note that audio levels can only be

monitored for analogue audio inputs.

Trap Target IP Address

Enter the IP address of the SNMP trap destination.

Low Audio Level

Deﬁne the low audio level for the trap which will be generated as soon as the audio level goes

below this value (and the “Silence timeout” has expired).

High Audio Level

Deﬁne the high audio level for the trap which will be generated as soon as the audio level goes

above this value.

20 Device Conﬁguration

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

Keine Kommentare

BARIX Streaming Client Bedienungsanleitung Seite 20