BARIX Streaming Client Betriebsanweisung PDF herunterladen (Seite 16)

NOTE: this takes up to 90 seconds in Encoder mode

Decoder configuration options:

 Buffer: the decoder stores (buffers) the incoming audio before playing it back;

this is to allow for the variable timing of the delivery of the audio over the

network. This buffering introduces a delay (latency) between the sent and

received audio. Choose the buffering value that best matches your needs for

latency and quality (too small a buffer can lead to audio artefacts caused by

the network 'jitter' (delay in delivery of the audio)

NOTE: Using a buffer setting of 100ms will automatically disable the flagging of

Stream Loss on local relay 1.

 Output level: the audio output can be amplified, adjust as necessary for your

audio equipment, to obtain best results.

 Use relay one to: Local relay one can be used to either automatically signal

stream loss, or show the value of the Project's Encoder Input 1.

Hardware devices with more than one relay output will automatically have their

other relay outputs set to the corresponding Encoder Input (2>2, 3>3 and so

on).

 Save as default: subsequent devices added to the project will have the same device

type as this device suggested as the default value.

When you have selected your configuration options for your first device, click on 'Create'.

This creates the Project with one device associated.

Barix Reflector User Guide.doc Page 16 of 22

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

BARIX Streaming Client Betriebsanweisung Seite 16